The UNI-BUG III is small enough to carry a cutting torch or welding gun into tight work areas or around very tight curves without the use of a track. The machine will mount and run directly on the work piece. The built-in carrying handle allows for easy mounting and removal at any point along the work piece. The unit is available in a variety of kits. Each kit is designed to fit on a specific steel profile such as flat bar, angle, channel, I-beams and bulb flats (holland profiles).
The UNI-BUG III features stitch welding which is programmable by distance. If you require stitch welding simply set the selector switch to the intermittent weld setting and program the length of weld required, the length of skip and also the required delay for puddle build and crater fill. Through the use of an integrated weld contactor the UNI-BUG III will activate and deactivate your wire feeder automatically.
The UNI-2500 UNI-BUG III Single Torch Kit is equipped for the mounting of a single torch and provides components to manually adjust the torch in the vertical and horizontal plane. The UNI-BUG III provides programmable control for stitch or continuous welding and is designed to mount and run on the top edge of a flat bar or stiffener with a minimum height of 2″ (50 mm) and a maximum width of 2″ (50 mm). The machine will turn on a radius down to 6″ (160 mm). The unit will travel at speeds from 4 to 75 inches per minute (102-1905 mm/min)
The UNI-2600 UNI-BUG III Dual Torch Welding Kit is the same as the UNI-2500, but is equipped for the mounting of two welding torches and provides components to manually adjust either torch in the vertical and horizontal plane.
The UNI-2700 UNI-BUG III Dual Torch Bulb Profile Welding Kit is equipped for the mounting of two welding torches and provides components to independently adjust either torch in the vertical and horizontal plane. The unit features programmable control for stitch or continuous welding and is designed for straight line welding of bulb flats. This unit will mount and run on bulb sizes from 140 mm to 430 mm. The unit will travel at speeds from 4 to 75 inches per minute (102-1905 mm/min).
The UNI-2800 UNI-BUG III Dual Torch “T” Profile Welding Kit is equipped for the mounting of two welding torches and pro- vides components to independently adjust either torch in the vertical and horizontal plane. The UNI-2800-4 works on “T” profiles 2”-4” (51-102 mm) range. The UNI-2800-6 works on “T” profiles 4”-6” (102-152 mm) range. The unit features programmable control for stitch or continuous welding and is designed for straight line welding of “T” profiles. This unit will mount and run on top of “T” profiles with a minimum height of 2″ (50 mm). The unit will travel at speeds from 4 to 75 inches per minute (102-1905 mm/min).
The UNI-2900 UNI-BUG III Dual Torch Angle Welding Kit is supplied with the mounts for two welding torches and provides components to independently adjust either torch in the vertical and horizontal plane. The unit features programmable control for stitch or continuous welding and is designed for straight line welding of angles. The unit will mount and run on top of angles with a minimum height of 4″ (102mm) and widths up to 4″ (102mm). The unit will travel at speeds from 4 to 75 inches per minute (102-1905mm/min).